Category Archives: Uncategorized

I really liked Margaret Sohn’s project. It seemed like a simple concept at first, but then the lights changed colors and I really liked that addition. I think this project was really fun to make and write a song for. Another one I liked was by Ethan Bailey, who created a little machine that playedContinue reading “ANalog Electronics Lab 13”

https://www.multisim.com/create/ 2. There’s a cool musical horn circuit that combines two 555 timers IC’s and it creates astable multivibrators.

1a. I love the T-Rex replicator tape echo pedal, not only for the really cool design but for how clear and beautiful the tape delay sounds. I also really liked the JAM Retrovibe pedal that gives a really cool vibrato to the sound and makes it feel like it’s from the 60’s. The last oneContinue reading “Analog Lab 11”

Multisim link: https://www.multisim.com/content/NVHZKzThcuSiC3xWudYVyb/katherine-gonick-lab-10/open/

Lab 9 answers: A B No Distorted signal, clean signal The exact averages of the 2 signals

Lab 8 Answers: Integrator – triangle wave, comparator – square wave Down, up Positive, negative Slower Add more oscillators

Part 4) You increase the resistance so it cancels out a higher number of frequencies. Part 5a) I think that I could make a revert guitar pedal. I personally don’t play guitar, but based off of the videos of previous projects I watched, I feel like I could make one and it would be funContinue reading “Analog Electronics Lab #4”

Adding a resistor and capacitor to this circuit is good because it protects the audio jack and audio system in your device from getting fried. The differences between the inverting and non-inverting amplifiers on the oscilloscope is that the inverting amplifier shows a wave that’s inverted and that goes to 0 when turned all theContinue reading “Analog Electronics Lab #5”

Using the oscilloscope: The input modes for bot channel 1 and 2: this receives the sound, can be set to ground so you don’t get anything through, just channel 1, just channel 2, or bot channel 1 and 2 Volt/Div. knob: lets you zoom in and out across the y axis by changing how manyContinue reading “Analog Electronics Lab #4”

Part 1a) Before you touch the soldering iron to what you’re about to solder, you must to a few things. Turn it on to 350 degrees and wait for it to warm up in the holder. Make sure to have a wet sponge nearby to clean off you soldering iron with when it gets dirty,Continue reading “Analog Electronics Lab #3”